Innovate lc 2 manual

Related Manuals for Innovate LC No related manuals. Summary of Contents for Innovate LC Page 1 When installed in the exhaust, the oxygen sensor MUST be connected and operating with the LC-2 whenever the car is running. An un-powered oxygen sensor will be quickly damaged when exposed to hot exhaust gases. Manual 1. Please follow the installation instructions that came with your wideband (LC-2, LC-1, LM-2, or LM-1) prior to installing the gauge. 2. Connect the DB gauge’s RED wire to a switched 12 volt source (ignition switched). 3. Connect the DB gauge’s BLACK ground wire to the same ground source shared with your wideband controller. www.doorway.ru Size: 23KB. This manual assumes that firmware version or later is installed. Warning! Innovate Motorsports HBX-1 heat sink bung extender. (p/n ) Alternatively you can also use the optional exhaust clamp (p/n ) to sample exhaust File Size: KB.

Manual 1. Please follow the installation instructions that came with your wideband (LC-2, LC-1, LM-2, or LM-1) prior to installing the gauge. 2. Connect the DB gauge’s RED wire to a switched 12 volt source (ignition switched). 3. Connect the DB gauge’s BLACK ground wire to the same ground source shared with your wideband controller. 4. Programmer and LC-2 manual can then be located by navigating through Start-Programs-LogWorks3. Connecting to LM Programmer LM Programmer is used to update firmware, change fuel types, and program the two analog outputs. 1. Connect the OUT port of the LC-2 to the provided serial programming cable. Connect the other end of the serial. 2 Wiring and Mounting the LC-1 Mounting 1. Find a suitable location under your vehicle where the LC-1 body can be mounted. Using zip ties or other suitable method, fasten the body of the LC-1 device securely to the frame-rails or other mounting points as far away from the heat of the exhaust system as the sensor cable allows.

Innovate Motorsports in partnership with Nordskog Instruments developed /16" (52mm) wideband air-fuel ratio gauges. With a red, blue or green LED for. Innovate's LogWorks software (included with the LM-2) or other 3rd party MTS- compatible applications. Locate the OBD-II Connector in your vehicle. Перевод инструкции Innovate LC-2 · Подключите КРАСНЫЙ провод к +12V источнику питания при зажигании. · ЧЕРНЫЙ провод должен быть заземлен на хороший источник.